The job below is no longer available.
You might also like
in Flower Mound, TX
CNC Machine Operator
•5 days ago
Estimated Pay | $23 per hour |
---|---|
Hours | Full-time, Part-time |
Location | Flower Mound, Texas 75028 Flower Mound, Texas |
Compare Pay
Estimated Pay We estimate that this job pays $23.13 per hour based on our data.
$17.26
$23.13
$34.82
About this job
Accurate and efficient set-up of the machine in accordance with proper setup techniques.
Properly operate machine to run efficiently, produce quality products and maximize machine utilization.
Assist operator in setup, production, quality, and housekeeping.
Set up and Run robotic feeder, maintain robotic feeder functions, clear scrap from feed area and work hand in hand with operator.
Check quality of boxes during the run, including - mis-slotted boxes, loose liner, misprints, and any other defects.
Complete necessary reports in an accurate and timely manner, including but not limited to: Production Data, Machine Operational Status, Safety Data, Quality Data.
Turn in maintenance work orders to supervision for needed repairs. Be proactive in the maintenance of equipment.
Must learn how to operate Flexo as this position will be back up to the operator.
Adheres to production schedule. Makes recommendations for optimizing the schedule to meet cost, quality, and service goals. Reports any unusual scheduling issues to Supervisor.
Comply with all company policies and procedures, including safety and maintaining good housekeeping.
Additional duties may be assigned by management.
SKILLS REQUIRED
Able to read and follow instructions on factory masters.
Able to read a tape measure with speed and accuracy. Able to calculate figures and amounts such as percentages, measurement, volume and rate. Able to apply concepts of high school math.