Assembly

ASSEMBLER

Pay rate: $15.75-$16.50/hr

Hours: 1st shift 6am-4pm. 2nd shift is 2p-10p. 3rd shift 8pm-6am. (MUST BE OPEN TO WORKING ANY SHIFT.)

REQUIREMENTS: High School Diploma or GED. Background check. Drug screen.

Job Description: specializes in the assembly of automotive seats and seat structures

• Line assembly – insert components into molds prior to foam pour

• Mold – using pneumatic hand tools to wax molds

• Demold – use hand tools and scrub pads to remove debris from molds for next foam pour

• Audit & Repair – Audit parts for defects, using pneumatic grinder and hand tools for repairs

• Packing – preparing, packing and labeling of product for shipment

• If demolding: Removes finished foam seating pads from their molds, places parts on a conveyer for the next stage of the finishing process and removes any obvious foam particles from the molds.

• If waxing: Removes any obvious foam particles from molds and applies a thin layer of demolding agent (aerosol wax) to the surface of the molds.

• Demolding: 1. Removes molded foam seat pads from molds. 2. Places part on conveyer for next stage of finishing process. 2. Cleans any foam particles and/or wax buildup from the molds. 3. Informs supervisor and line technician of process problems underfills, wax burns, etc.

• If Waxing: Able to operate and properly calibrate aerosol wax gun Must be proficient in knowledge and application of all applicable standards and work instructions pertaining to the specific parts assigned.

• Waxing: 1. Cleans foam particles and/or wax buildup from molds 2. Applies spray wax to the mold surfaces 3. Notifies supervisor and line technician of process problems • If Repairing: Specific Duties All positions clean work area during periods of downtime and at the conclusion of shift and perform various duties assigned by supervisor.

• Trimming: 1. Removes all ribbon vents and uncontrolled flash on parting line that is greater than 25mm using scissors or air trimmer tool. 2. Inspects parts for the following defects. a. Flash not trimmed off. b. Hard spots on the parting line. c. Under fills d. Foam free areas 3. Safety glove must be worn on opposite hand. 5. See specialized customer required trim areas